Effluent Pond Stirrers

Your EPS stirrer usually is set up to run 24/7 when first installed but because of the very low kW/hrs they use they are very very cheap to run. But once you are on top of your pond conditions you can then get your electrician to set it up to run for a few hours every day about the time your pump runs to ensure your pump can suck up all the beautifully blended mix and send it on its way back to your paddock.

Because of the low hp and shaft speeds the EPS stirrers are super reliable even when the odd object gets caught up around the blade or shaft from time to time. When this happens you can tell by the stirrer wobbling around on its raft or it may stop because it may trip the electrical circuit breaker. If this happens you simply float your stirrer to the side of the pond lift it out, take off the build up, refloat and restart.

Please see over the page for some of the other effluent management equipment Pluck’s Engineering manufacture, which is all available through us or your local effluent dealer.

Your pond will stay clean, crust free, sludge free and look outstanding when the Environment officers call round.