Plucks Engineering Irrigation Systems

LP25 & LP30 Travelling Irrigators
Fully Galvanised - Suitable for Dairy or Piggery Effluent or Standard Spray Irrigation

The LP25 Model - Low Cost Travelling Rotary Irrigator, of very solid construction, winds itself along on a wire rope driven by the rotating arms through a ratchet gear. Automatically stops at the end of each run.

Drag Hose: designed for 2" (50mm) alkathene or lay-flat hose. For both LP25 and LP30 models.

Bearing Areas: Main Pivot Boss, special hard wearing Nylon, Drum shaft bearings, special seal, self aligning greaseable.

Flow Rates: works very efficiently with flow rates from 50 gpm (230 Ipm) up to 100 gpm (450 Ipm)
PSI - KPA: 30-35 psi at Irrigator.
206-240 kpa

Covering Width: LP25 Model: 25-26 Metres.
LP30 Model: 28-30 Metres.
Depending on flow rate and pressure.

Length of Arms: LP25 Model: 3.5 m giving 7 m span (23 ft.).
LP30 Model: 5.2 m giving 10.4 m span (34 ft.).

Run Length: LP25 Model: Normal length of drag hose 100m,
giving 200m run - longer runs are achievable with higher flow rates.
LP30 Model 300m runs.

Eight Ground Speed: settings govern the amount spread in each pass.
This allows for effluent to be applied at very low application rates according to regulations for your area.

N.B Specifications may change without notice.

For more information, email here.

Top